Direct Adaptive Steering System

Check the main motor angle sensor. Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 2.

NO

Main motor angle sensor is malfunction. Replace steering gear assembly. Refer to STEERING GEAR AND LINKAGE : Removal & Installation .

1. Disconnect steering angle main control module and main motor angle sensor harness connector.
2. Check the continuity between control module harness connector and angle sensor harness connector.

   Steering angle main control module		Main motor angle sensor		Continuity
   Connector	Terminal	Connector	Terminal
   E26	10	E93	3	Existed
   	11		6
   	6		1
   	5		5
   	4		2
   	2		4

3. Check the continuity between control module harness connector and ground.

   Steering angle main control module		--	Continuity
   Connector	Terminal
   E26	10	Ground	Not existed
   	11
   	6
   	5
   	4
   	2

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace error-detected part.

1. Check enlarged contact spring of terminal. Refer to Inspection .
2. Perform intermittent incident while turning steering wheel. Refer to Inspection .

Is the inspection result normal?

YES

Replace steering angle main control module. Refer to STEERING ANGLE MAIN CONTROL MODULE : Removal & Installation .

NO

Repair or replace error-detected part.