LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2021 >> Q50 Pure, AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Transfer Case (Diagnostics) >> Description >> Diagnosis System (AWD Control Unit) >> Consult Function >> Diagnosis Description >> Data Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data Monitor

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item (Unit)

Remarks

STOP LAMP SW [On/Off]

Stop lamp switch signal status via CAN communication line is displayed.

ENG SPEED SIG [Run/Stop]

Engine status is displayed.

ETS ACTUATOR [On/Off]

Operating condition of AWD actuator relay (integrated in AWD control unit) is displayed.

4WD WARN LAMP [On/Off]

Control status of AWD warning (on information display) is displayed.

4WD MODE SW [No. No. ] *1

Mode switch is not equipped, but displayed.

4WD MODE MON [AUTO]

Control status of AWD is displayed.

DIS-TIRE MONI [mm]

Improper size tire installed condition is displayed.

P BRAKE SW [On/Off]

Parking brake switch signal status via CAN communication line is displayed.

BATTERY VOLT [V]

Power supply voltage for AWD control unit.

THRTL POS SEN [%]

Throttle opening status is displayed.

ETS SOLENOID [A]

Monitored value of current at AWD solenoid.

FR RH SENSOR [km/h] or [mph]

Wheel speed calculated by front RH wheel sensor signal is displayed.

FR LH SENSOR [km/h] or [mph]

Wheel speed calculated by front LH wheel sensor signal is displayed.

RR RH SENSOR [km/h] or [mph]

Wheel speed calculated by rear RH wheel sensor signal is displayed.

RR LH SENSOR [km/h] or [mph]

Wheel speed calculated by rear LH wheel sensor signal is displayed.

*1: It is not setting, but it is displayed.