Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE-I
- Turn ignition switch ON and wait at least 5 seconds.
- Check DTC.
Is DTC P010D detected?
YES
Refer to DTC Diagnosis Procedure .
NO
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE-II
- Start engine and wait at least 5 seconds.
- Check DTC.
Is DTC P010D detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END