LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2021 >> Q60 Pure, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (2 Of 7) >> Engine (ECM) >> DTC P0125: ECT Sensor >> Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Procedure

  1. CHECK DTC PRIORITY 

    If DTC P0125 is displayed with DTC P0117 or P0118, first perform the confirmation procedure (trouble diagnosis) for DTC P0117 or P0118.

    Is DTC P0117 or P0118 detected?

    YES

    Perform diagnosis of applicable.

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 3.

  3. CHECK ENGINE COOLANT TEMPERATURE SENSOR FUNCTION 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. On CONSULT screen, select "ENGINE">>"Data Monitor".
    3. Check that "COOLAN TEMP/S" is above -10 deg.C (14 deg.F).

    Is the temperature above -10 deg.C (14 deg.F)?

    YES

    INSPECTION END

    NO

    GO TO 4.

  4. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL With CONSULT

    1. Start engine and run it for 65 minutes at idle speed.

      If "COOLAN TEMP/S" increases to more than -10 deg.C (14 deg.F) within 65 minutes, stop engine because the test result will be OK.

      CAUTION: Be careful not to overheat engine.
    2. Check 1st trip DTC.

    Is DTC P0125 detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END