Work Procedure

CONSULT Configuration

Select "Re/programming, Configuration" of "MULTI AV".

When writing saved data

GO TO 2.

When writing manually

GO TO 3.

CONSULT Configuration

Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to AV control unit.

GO TO 4.

CONSULT Configuration

1. Select "Re/programming, Configuration" of "MULTI AV".
2. Select "Manual Configuration", and write the setting value as shown in the following table to AV control unit according to the vehicle specification.
   CAUTION: Grasp vehicle specifications precisely. The control of ECU control may not function normally if the specifications are misread.
   NOTE:

   • The items shown in the list depend on vehicle specifications.
   • The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
   • If selection items are not displayed on the CONSULT screen, touch "NEXT".

   MANUAL SETTING ITEM		Detail
   Items	Setting value
   NAVIGATION	WITH	Models with navigation system
   	WITHOUT	Models without navigation system
   SOUND SYSTEM	BOSE	Models with Bose audio
   	NORMAL 6SPKS	Models without Bose audio
   CAMERA SYSTEM	NONE or AVM ph3	Models with Intelligent around view monitor system
   	REAR	Models with rear view monitor system
   SONAR TYPE	None	Models without sonar
   	REAR	Models with sonar
   PREDICTIVE COURSE LINE	Without or with (with AVM)	Models with Intelligent around view monitor or without camera
   	With (Rear view camera)	Models with rear view monitor

GO TO 4.

CONSULT Self Diagnostic Result

Perform self-diagnosis of CONSULT, and check whether or not DTC B1341-55 is detected.

Is DTC B1341-55 detected?

YES

GO TO 1.

NO

GO TO 5.

Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.

YES

Work End.