System Description: Description

This function allows the driver side seat and the steering column to return from the exiting position to the position before the exiting function is operated when the push-button ignition switch is operated from OFF to ACC when the driver enters the vehicle.
If the push-button ignition switch is operated with any Intelligent Key other than that used before the exiting function is operated, the driver side seat and the steering column will return to the driver position registered for that Intelligent Key.

NOTE:

Operation Condition

Ignition switch ON.
Driver seat and steering column will return from the exiting position to entry position.

Operation Procedure

Satisfy all of the following items. The entry assist function is not performed if these items are not satisfied.

Item	Request status
Seat, steering column	The vehicle is not moved after performing the exit assist function.
Switch inputs Power seat switch Tilt & telescopic switch Door mirror control switch Set switch Memory switch	OFF (Not operated)
Vehicle speed	0 Km/h (0 MPH)
Starter	OFF
Transmission	CVT
CONSULT	Not connected

Detail Flow

Order	Input	Output	Control unit condition
1	Ignition switch	--	Driver seat control unit receives the signals of [ignition switch signal] from BCM via CAN communication.
2	--	Motors (Sliding, tilt)	Driver seat control unit operates the sliding motor when the operating conditions are satisfied and requests the operations of tilt motor to automatic drive positioner control unit via UART communication. The automatic drive positioner control unit operates each motor.
3	Sensors (Sliding, tilt)	--	Each sensor monitors the operating positions of seat and steering column, and then stops the operation of each motor when each part reaches the recorded positions.