Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect steering force control module harness connector and steering angle main control module harness connector.
3. Check the continuity between steering force control module harness connector and steering angle main control module harness connector.

   Steering force control module		Steering angle main control module		Continuity
   Connector	Terminal	Connector	Terminal
   E141	23	E149	23	Yes

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace malfunctioning component.

CONSULT

1. Connect steering force control module harness connector and steering angle main control module harness connector.
2. Ignition switch ON.
3. On the CONSULT screen, select "DAST 1">>"DATA MONITOR">>"SUB IGN VOLTAGE".
4. Check the value

   Monitor item	Standard value (Approx.)
   SUB IGN VOLTAGE	Battery voltage

Is the inspection result normal?

YES

GO TO 3.

NO

Replace steering force control module. Refer to Removal and Installation .

CONSULT

1. Ignition switch OFF.
2. Connect steering angle main control module harness connector.
3. Ignition switch ON.
4. Erase "Self Diagnostic Result" mode of "DAST 1".
5. Ignition switch OFF and wait for at least 10 seconds.
6. Start the engine.
   CAUTION: Never drive the vehicle.
7. Select "Self Diagnostic Result" mode of "DAST 1".

Is DTC "C13BD-00" detected?

YES

Replace steering angle main control module. Refer to Removal and Installation .

NO

• Check enlarged contact spring of terminal. Refer to How to Check Terminal .
• Perform intermittent incident while turning steering wheel. Refer to Intermittent Incident .