Component Inspection

1. Ignition switch OFF.
2. Disconnect force motor angle sensor harness connector.
3. Check resistance between force motor angle sensor connector pin terminals.

   Force motor angle sensor		Condition	Resistance (Approx.)
   Terminal
   3	7	0 deg. C	34.8 k Ohm
   		25 deg. C	10.0 k Ohm
   		40 deg. C	5.2 k Ohm

4. Check continuity between force motor angle sensor connector and ground.

   Force motor angle sensor	--	Continuity
   Terminal
   3	Ground	No
   7

Is the inspection result normal?

YES

Inspection End.

NO

Force motor temperature sensor is malfunction. Replace steering column assembly. Refer to Removal and Installation .