DTC Confimation Procedure
NOTE:
If calibration data has not been written to TCM, write the calibration data to the TCM first.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE - 1
- Turn ignition switch ON and wait for 5 seconds or more.
- Check DTC.
Is "P0701-00 detected?
YES
Go to DTC Diagnosis Procedure .
NO
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE - 2
- Start the engine.
- Depress the brake pedal.
- Shift the selector lever to "R" position and wait for 5 seconds or more.
- Check DTC.
Is "P0701-00 detected?
YES
Go to DTC Diagnosis Procedure .
NO
GO TO 4.
- PERFORM DTC CONFIRMATION PROCEDURE - 3
- Shift the selector lever to "Nr" position and wait for 5 seconds or more.
- Check DTC.
Is "P0701-00 detected?
YES
Go to DTC Diagnosis Procedure .
NO
GO TO 5.
- PERFORM DTC CONFIRMATION PROCEDURE - 4
- Shift the selector lever to "D/M" position and wait for 5 seconds or more.
- Check DTC.
Is "P0701-00 detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Go to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END