DTC Confimation Procedure

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2.

1. Turn ignition switch ON.
2. Select "Data Monitor" in "SHIFT".
3. Select "SHIFT POSITION JUDGMENT".
4. Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)

   H -> Nr -> R -> Nd -> D/M -> H

5. Repeat step 4 five times.
6. Check DTC.

Is "P07ED-00 detected?

YES

Go to DTC Diagnosis Procedure .

NO

To check malfunction symptom before repair: Go to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END