Component Inspection (Shift Actuator Relay)

1. Disconnect the shift actuator relay A. Refer to Component Location .
2. Apply 12 V direct current between shift actuator relay A terminals 3 and 4.
   CAUTION:

   • Never make the terminals short.
   • Connect the fuse between the terminals when applying the voltage.
3. Check the continuity between shift actuator relay A terminals 1 and 2.

   Shift actuator relay A		Condition	Continuity
   Terminal
   1	2	Apply 12 V direct current between terminals 3 and 4.	Existed
   		Does not apply 12 V direct current between terminals 3 and 4.	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace the shift actuator relay A.