Active Test

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT to check operation of actuator.

Test item

Condition

Description

ETS S/V

(Detects AWD solenoid)

Vehicle stopped
Engine running
No DTC detected

Change command current value to AWD solenoid, and then change driving mode. (Monitor value is normal if it is within approx. +/-10% of command value.)

Qu: Increase current value in increments of 0.2 A
Qd: Decrease current value in increments of 0.2 A
UP: Increase current value in increments of 0.02 A
DOWN: Decrease current value in increments of 0.02 A

CAUTION: Never energize continuously for a long time.