Work Procedure
- CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES
GO TO 2.
NO
Repair battery terminals connection.
- CHECK FUSE
Check for blown fuse and fusible link.
Unit
Power source (Power supply terminals)
Fuse No.
Alternator
Battery ("S" terminal)
32
Combination meter
Ignition switch ON ("L" terminal)
3
Is the inspection result normal?
YES
GO TO 3.
NO
Replace the blown fuse after repairing the applicable circuit.
- CHECK "E" TERMINAL CONNECTION
Check if "E" terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair "E" terminal connection.
- CHECK DRIVE BELT TENSION
Check drive belt tension.
Is the inspection result normal?
YES
INSPECTION END
NO
Repair as needed.