Confirmation Procedure
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.
- Before performing the following procedure, check that the engine coolant temperature is -10 deg.C (14 deg.F) or more.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and let it idle for at least 5 seconds.
If engine does not start, crank engine for at least 5 seconds.
- Check DTC.
Is DTC detected?
YES
Refer to DTC Diagnosis Procedure .
NO
INSPECTION END
- Start engine and let it idle for at least 5 seconds.