DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms(Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C13BD-00 | CONTROL MODULE IGN POWER SUPPLY(Control module ignition power supply) | Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | - | ||
| Threshold | The malfunction in CAN wake up circuit is detected | ||
| Diagnosis delay time | 1 seconds or more | ||
POSSIBLE CAUSE
- Harness and connector
- CAN wake up circuit (open or short)
- Steering force control module
- Steering angle main control module
FAIL-SAFE
Mode 2
NOTE:
For fail-safe mode, refer to Fail-safe
.
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
- If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Ignition switch ON.
- Select "Self Diagnostic Result" mode of "EPS/DAST 3", "DAST 1" or "DAST 2".
Is DTC "C13BD-00" detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>
Confirmation after repair: Inspection End.