Work Procedure

WARNING: Never move the vehicle during "DAST CALIBRATION (MODE1)" because the steering gear is held in neutral position until placing the ignition switch OFF.

CAUTION:

Be careful for the moving parts, steering wheel and front wheels are steered automatically when start "DAST CALIBRATION (MODE1)".
Do not rotate road wheels during the DAST calibration because the system is detected the vehicle running.

PREPARATION
1. CONSULT
  1. Set the front wheel on the turn table.
    NOTE: Do not lift up the vehicle during "DAST CALIBRATION (MODE1)".
  2. Connect the battery charger to protect the battery.
    NOTE: "DAST CALIBRATION (MODE1)" has a high current draw.
  3. Ignition switch ON.
    CAUTION:
    Never start the engine.
>>

GO TO 2.
ECU CONFIGURATION
1. CONSULT
  1. Perform configuration for steering force control module. Refer to Work Procedure .
  2. Perform configuration for steering angle main control module. Refer to Work Procedure .
  3. Perform configuration for steering angle sub control module. Refer to Work Procedure .
>>

GO TO 3.
PREPARATION BEFORE DAST CALIBRATION
1. Confirm that rear cap projection of steering gear is aligned in the center of the lower joint. Perform "INSPECTION AFTER INSTALLATION." Refer to Removal and Installation .
Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair as necessary, GO TO 4.
DAST CALIBRATION (MODE1) [CLUTCH PHASE LEARNING]
1. CONSULT
  1. Perform "DAST CALIBRATION (MODE1)". Refer to Description .
  2. Ignition switch OFF.
    CAUTION:
    Be sure to perform this step.
>>

GO TO 5.
DAST CALIBRATION (MODE1) [STEERING RACK NEUTRAL POSITION LEARNING]
1. CONSULT Perform "DAST CALIBRATION (MODE1)". Refer to Description .
>>

GO TO 6.
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
1. CONSULT
  1. Select "ST ANGLE SENSOR ADJUSTMENT" in "Work support" mode of "ABS".
  2. Select "Strat".
    CAUTION:
    Never touch steering wheel while adjusting steering angle sensor.
  3. After approx. 10 seconds, select "End".
  4. Ignition switch OFF, then place it ON again.
    CAUTION:
    Be sure to perform this step.
>>

GO TO 7.
PERFORM SELF-DIAGNOSIS
1. CONSULT
  1. Ignition switch OFF and wait at least 10 seconds.
  2. Start the engine.
    CAUTION:
    Never drive the vehicle.
  3. Select "Self Diagnostic Result" mode of "EPS/DAST 3", "DAST 1" and "DAST 2".
Is any DTC detected?

YES>>

When other than above DTC is detected, perform trouble diagnosis for the detected DTC. Refer to DTC Index (EPS/DAST 3), DTC Index (DAST 1), DTC Index (DAST 2).

NO>>

GO TO 8.

FINAL CONFIRMATION

CONSULT

Ignition switch ON.
CAUTION:
Never start the engine.

Select "ANGLE 1" in "Data Monitor" mode of "EPS/DAST 3" and check the value.

Monitor item	Standard value
ANGLE 1	-4.4 ≤ ANGLE 1 ≤ 4.4

Is the confirmation result normal?

YES>>

Inspection End.

NO>>

Slightly lower the tilt position, and then re-perform Work Procedure .