LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2001 >> Rodeo LS, 2.2 D >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Transfer Case) >> Transfer Case Assembly >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Transfer Case Assembly: Installation

WARNING: This page is about a different car, the 2003 Isuzu Rodeo Sport, 2003 Isuzu Rodeo, 2002 Isuzu Rodeo Sport, and 2002 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a thin coat of molybdenum disulfide grease to the input shaft spline as shown in the figure.
    Fig 1: Applying A Thin Coat Of Molybdenum Disulfide Grease To Input Shaft Spline
    G02789940Courtesy of ISUZU MOTOR CO.
  2. Install transfer case (10) to the transmission. Tighten transfer bolts as shown in the figure.

    For M/T 

    Fig 2: Tightening Transfer Bolts (M/T)
    G02789941Courtesy of ISUZU MOTOR CO.

    For A/T 

    Fig 3: Tightening Transfer Bolts (A/T)
    G02789942Courtesy of ISUZU MOTOR CO.
  3. Remove the transmission jack from transmission side.
  4. Connect harness connectors and clip.
    1. Connector: transfer switch, 2WD-4WD actuator, speed sensor.
  5. Install rear propeller shaft (1) and front propeller shaft (2).

Torque:  63 N.m (46 lb ft)

scientia non olet · About LEMON Manuals