Section 40 (Transfer Case)
WARNING: This page is about a different car, the 2003 Isuzu Rodeo Sport, 2003 Isuzu Rodeo, 2002 Isuzu Rodeo Sport, and 2002 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.
- Service Precaution
- General Description
- Transfer Rear Oil Seal
- Transfer Case Assembly
- Transfer Control Unit
- Transfer Disassembly
- Main Data and Specifications
- Transfer Case Control System
- Transfer Controller
- Notes
- Removal
- Installation
- Function of Switch and Indicator Lamp
- 2H to 4H Retrial
- Parts Location
- Circuit Diagram
- Connector List
- Diagnosis
- Diagnosis From Symptom
- Check 4WD Lighting Up
- Cannot shift from 2WD to 4H or 4L. When shifting from 2H to other position, the indicator (4WD, 4Lo, Check 4WD) does not respond.
- Even after correction step 1-1(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz and clicking sound of relay continues.
- Even after the correction step 1-2(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz when shifting with clicking sound of relay from 2H to 4H.
- After operation, indicator of target position blinks for 1.5 sec. at 2Hz, return to 2H condition (4WD indicator going out)
- Transfer cannot shift to a position other than 4H. When shifting from 4H to other position, indicator (4WD, 4Lo, Check 4WD) does not respond (Only 4WD keeps lighting).
- Even after the correction step 2-1(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz when shifting from 4H to 2H.
- Though the indicator responds when shifting from 4H to 2H (or other position), it returns to 4H.
- From 4H to 4L; Even after the correction step 3-3(Before determining a trouble (Non-trouble mode)), 4Lo indicator blinks at 4Hz
- From 4L to 4H: After the correction step 4-3(Before determining a trouble (Non-trouble mode)), 4Lo indicator blinks at 4H.