LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2001 >> Rodeo LS, 2.2 D >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Transfer Case) >> Transfer Controller >> Diagnosis >> Memory Erasing Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Memory Erasing Procedure

WARNING: This page is about a different car, the 2003 Isuzu Rodeo Sport, 2003 Isuzu Rodeo, 2002 Isuzu Rodeo Sport, and 2002 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare two pieces of short harness with the end shaped like a needle (about 20 cm (7.9 in) long).
  2. Turn OFF the ignition.
  3. Remove the center console.
  4. Keeping the connector of the transfer controller connected, set the short harness from the back of the connector as illustrated.
  5. Turn ON the ignition, wait for 2 seconds, and turn OFF the ignition after confirming the relay sound.
  6. Disconnect the short harness, turn ON the ignition again, and confirm the "Check 4WD" lamp in the meter panel is OFF.
  7. Before erasing the memory, check that the circuit of the T/F actuator position detection harness, etc. for it are normal.
scientia non olet · About LEMON Manuals