Window Regulator: Removal

Remove the 8 nuts and regulator. See Fig 1 and Fig 6 .

NOTE: Apply MP grease to the sliding surface and gears of the window regulator. See Fig 2 and Fig 7 . Do not apply MP grease to the spring of the window regulator.

Disconnect the connector.

NOTE: The screws and cover plate can be used again.

To replace the regulator, (screw type) remove the 2 screws and remove the cover. See Fig 3.

CAUTION: Do not damage the motor housing.

NOTE: Tape screwdriver tip before use.

NOTE: The cover plate is not reusable.

(Crimped type) Using a screwdriver, pry up the cover plate tab and remove the cover plate. See Fig 4.

CAUTION: Do not use a screwdriver etc. to help remove them.

Remove the drum and wire guide from motor. See Fig 5.

Fig 1: Removing Window Regulator (Front)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Applying Grease To Window Regulator (Front)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: Removing Cover Plate (Screw Type)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 4: Removing Cover Plate (Crimped Type)

Fig 5: Removing The Drum & Wire Guide

Fig 6: Removing Window Regulator (Rear)

Fig 7: Applying Grease To Window Regulator (Rear)