Circuit Description

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

The power slide door operates only when the power slide door main switch is ON (switch free: orange paint on the top of the switch appears). The power slide door ECU RH controls the power slide door RH, which activates the slide door motor to open/close the slide door.
A request signal from the satellite switch for the power slide door RH is input to the driver side junction block ECU, which then sends this request signal using a BEAN line to the power slide door ECU RH.
A request signal from the power slide door control switch RH is directly input to the power slide door ECU RH.
When the child lock is in the locked condition, the power slide door control switch RH is disabled, thus the power slide door RH is not activated by this switch.
When the touch sensor has an open/short-circuit, closing of the power slide door is disabled.

NOTE: When disconnecting the negative (-) terminal cable of the battery or control motor and clutch, initialize the power slide door system (See PRE-CHECK ).