LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2004 >> RX 330 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Navigation) >> Navigation System >> System Normal Condition Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

System Normal Condition Check

WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK NORMAL CONDITION 
    1. If the symptom is applicable to any of the following, it is intended behavior, and not a malfunction.
      SYSTEM TABLE

      Symptom Answer
      A longer route than expected is chosen. Depending on the road conditions, the navigation ECU may determine that a longer route is quicker.
      Even when distance priority is high, the shortest route is not shown. Some paths may not be advised due to safety concerns.
      When the vehicle is put into motion immediately after the engine starts, the navigation system deviates from the actual position. If the vehicle starts before the navigation system activates, the system may not react.
      When running on certain types of roads, especially new roads, the vehicle position deviates from the actual position. When the vehicle is driving on new roads not available on the map disc, the system attempts to match it to another nearby road, causing the position mark to deviate.
    2. The following symptoms are not a malfunction, but are caused by errors inherent in the GPS, gyro sensor, speed sensor, and navigation ECU.
      1. The current position mark may be displayed on a nearby parallel road.
        Fig 1: Identifying Position Mark On Parallel Road
        G04945229Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Immediately after a fork in the road, the current vehicle position mark may be displayed on the wrong road.
        Fig 2: Identifying Vehicle Position Mark On Wrong Road
        G04945230Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. When the vehicle turns right or left at an intersection, the current vehicle position mark may be displayed on a nearby parallel road.
        Fig 3: Identifying Vehicle Position Mark On Parallel Road
        G04945231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. When the vehicle is carried, such as on a ferry, and the vehicle itself is not running, the current vehicle position mark may be displayed in the position where the vehicle was until a measurement can be performed by GPS.
        Fig 4: Checking Vehicle Position When Vehicle Carried
        G04945232Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. When the vehicle runs on a steep hill, the current vehicle position mark may deviate from the correct position.
        Fig 5: Identifying Vehicle Position Mark In Correct Position - Runs On Steep Hill
        G04945233Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      6. When the vehicle makes a continuous turn of 360, 720, 1,080, etc. degrees, the current vehicle position mark may deviate from the correct position.
        Fig 6: Identifying Vehicle Position Mark In Correct Position - Continuous Turn
        G04945234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      7. When the vehicle moves erratically, such as constant lane changes, the current vehicle position mark may deviate from the correct position.
        Fig 7: Identifying Vehicle Position Mark In Correct Position - Erratically
        G04945235Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      8. When the ignition switch is turned to the ACC or ON position on a turntable before parking, the current vehicle position mark may not point in the correct direction. The same will occur when the vehicle comes out of parking.
        Fig 8: Normal Condition Check - Engine Switch Turned On (ACC Or ON)
        G04945236Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      9. When the vehicle runs on a snowy road or a mountain path with the chains installed or using a spare tire, the current vehicle position mark may deviate from the correct position.
        Fig 9: Identifying Vehicle Position Mark In Correct Position - Runs On Snowy Road
        G04945237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      10. When a tire is changed, the current vehicle position mark may deviate from the correct position.

        HINT:

        • Diameter of the tire may change, causing a speed sensor error.
        • Performing the "tire change" in calibration mode will allow the system to correct the current vehicle position faster.
          Fig 10: Identifying Vehicle Position Mark In Correct Position - Tire Change
          G04945238Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002