Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the speed sensor front with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE: Prevent foreign matter from attaching to the sensor tip.
  
  Fig 1: Locating Speed Sensor Front With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the speed sensor front with the 2 bolts and the clamp.
  Torque: Bolt A
  
  5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Bolt B
  
  29 N*m (296 kgf*cm, 21 ft.*lbf)
  
  NOTE: Do not twist the sensor wire when installing the sensor.
3. Connect the speed sensor connector.
  
  Fig 2: Locating Speed Sensor Front With Bolts And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK ABS SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE ).