Tire Pressure Monitor Receiver: Replacement

HINT:

COMPONENTS: See COMPONENTS

1. SHIP MODE SETTING (See  RADIO RECEIVER ASSY  ) 
2. SEPARATE BATTERY NEGATIVE TERMINAL 
   1. Disconnect the negative terminal.
3. REMOVE CONSOLE UPPER PANEL GARNISH REAR (See  REPLACEMENT  ) 
4. REMOVE CONSOLE PANEL SUB-ASSY UPPER (See  REPLACEMENT  ) 
5. REMOVE AIR CONDITIONER CONTROL ASSY (See  OVERHAUL  ) 
6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY LOWER CENTER (See  RADIO RECEIVER ASSY  ) 
7. SHIP MODE CONFIRMATION (See  RADIO RECEIVER ASSY  ) 
8. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSY 
   1. Disconnect the 2 connectors.
   2. Remove the 2 bolts and receiver assy.
   Fig 1: Removing Bolts & Receiver Assy

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSY 
   1. Install the receiver assy with the 2 bolts.

      Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf) 

   2. Connect the 2 connectors.
   Fig 2: Installing Receiver Assy With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. INSPECT TIRE PRESSURE WARNING SYSTEM (See  PRE-CHECK  ) 

SST 09843-18040