LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System And Circuit Testing, Active Control Engine Mount System (Including DTC P16A0 - P16A4), On-Vehicle Inspection, Removal, Inspection & Installation >> Acceleration Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Acceleration Sensor: Installation

  1. INSTALL ACCELERATION SENSOR 
    1. Install the acceleration sensor with the 2 nuts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Fig 1: Identifying Acceleration Sensor With Nuts
      G05247992Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the acceleration sensor connector and clamp.
      Fig 2: Identifying Acceleration Sensor Connector & Clamp
      G05247991Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  3. INSTALL AIR CLEANER INLET ASSEMBLY  (See INSTALLATION )
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  6. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  7. INSTALL ENGINE UNDER COVER RH 
  8. INSTALL ENGINE UNDER COVER LH 
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).
      NOTE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.
scientia non olet · About LEMON Manuals