LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System And Circuit Testing, Active Control Engine Mount System (Including DTC P16A0 - P16A4), On-Vehicle Inspection, Removal, Inspection & Installation >> Active Control Engine Mount Ecu >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Active Control Engine Mount Ecu: Installation

  1. INSTALL ACTIVE CONTROL ENGINE MOUNT ECU 
    1. Install the active control engine mount ECU with the nut.

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

      Fig 1: Identifying Active Control Engine Mount ECU With Nut
      G05247997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
      Fig 2: Identifying Connector
      G05247996Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LOWER INSTRUMENT PANEL RH  (See INSTALLATION )
  3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  4. INSTALL FRONT DOOR OPENING TRIM COVER RH  (See INSTALLATION )
  5. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  7. INSTALL SIDE INSTRUMENT PANEL RH  (See INSTALLATION )
  8. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  9. INSPECT FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See ON-VEHICLE INSPECTION )
  10. INSPECT SRS WARNING LIGHT  (See ON-VEHICLE INSPECTION )
  11. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).
      NOTE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.
scientia non olet · About LEMON Manuals