VVT Sensor: Installation

INSTALL VVT SENSOR (for Bank 2 Exhaust Side)
1. Install the VVT sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Identifying Bolt On VVT Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the VVT sensor connector.
INSTALL VVT SENSOR (for Bank 2 Intake Side)
1. Install the VVT sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Identifying Bolt On VVT Sensor For Bank 2 Intake Side
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the VVT sensor connector.
INSTALL VVT SENSOR (for Bank 1 Exhaust Side)
1. Install the VVT sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 3: Identifying Bolt On VVT Sensor For Bank 1 Exhaust Side
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the VVT sensor connector.
INSTALL VVT SENSOR (for Bank 1 Intake Side)
1. Install the VVT sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 4: Identifying Bolt On VVT Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the VVT sensor connector.
INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER INLET ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
ADD ENGINE COOLANT (See ON-VEHICLE INSPECTION )
CHECK FOR ENGINE COOLANT LEAKS (See ON-VEHICLE INSPECTION )
INSTALL FRONT SUSPENSION UPPER CENTER BRACE (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL ENGINE UNDER COVER RH
INSTALL ENGINE UNDER COVER LH