LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 350 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection, Installation >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    Fig 1: Locating Engine Coolant Temperature Sensor
    G05285367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install a new gasket to the sensor.
    2. Install the sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Connect the sensor connector.
  2. INSTALL INTAKE MANIFOLD (See INSTALLATION )
  3. INSTALL INTAKE AIR SURGE TANK (See INSTALLATION )
  4. INSTALL THROTTLE BODY (See INSPECTION )
  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See KNOCK SENSOR )
  6. CONNECT NO. 2 VENTILATION HOSE (See KNOCK SENSOR )
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  8. INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )
  9. INSPECT FUNCTION OF THROTTLE BODY (See ON-VEHICLE INSPECTION )
  10. ADD ENGINE COOLANT (See REPLACEMENT )
  11. INSPECT FOR COOLANT LEAK (See COOLING SYSTEM )
  12. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
  13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
  14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
  15. INSTALL FRONT FENDER TO COWL SIDE SEAL LH (See INSTALLATION )
  16. INSTALL FRONT FENDER TO COWL SIDE SEAL RH (See INSTALLATION )
  17. INSTALL FRONT UPPER FENDER PROTECTOR LH (See INSTALLATION )
  18. INSTALL FRONT UPPER FENDER PROTECTOR RH (See INSTALLATION )
  19. INSTALL V-BANK COVER (  INSTALLATION  ) 
  20. INSTALL ENGINE ROOM SIDE COVER LH (  INSTALLATION  ) 
  21. INSTALL ENGINE ROOM SIDE COVER RH (  INSTALLATION  ) 
  22. INSTALL COOL AIR INTAKE DUCT SEAL (  INSTALLATION  ) 
  23. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals