LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 350 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection, Installation >> Engine Coolant Temperature Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
  4. REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
  5. REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
  6. REMOVE V-BANK COVER (See REMOVAL )
  7. REMOVE FRONT UPPER FENDER PROTECTOR LH (See REMOVAL )
  8. REMOVE FRONT UPPER FENDER PROTECTOR RH (See REMOVAL )
  9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (See REMOVAL )
  10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (See REMOVAL )
  11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See REMOVAL )
  12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See REMOVAL )
  13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See REMOVAL )
  14. DRAIN ENGINE COOLANT (See COOLANT )
  15. DISCONNECT NO. 2 VENTILATION HOSE (See INSPECTION )
  16. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (See INSPECTION )
  17. REMOVE THROTTLE BODY (See INSPECTION )
  18. REMOVE INTAKE AIR SURGE TANK (See REMOVAL )
  19. REMOVE INTAKE MANIFOLD (See REMOVAL )
  20. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
      Fig 1: Locating Engine Coolant Temperature Sensor
      G05285367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the sensor.
    3. Remove the gasket from the sensor.
scientia non olet · About LEMON Manuals