LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 350 AWD >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering >> Electronic Power Steering System >> Freeze Frame Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Freeze Frame Data

  1. FREEZE FRAME DATA 
    NOTE:
    • If is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.
    • Turn the engine switch on (IG) and park the vehicle on level ground. Check the freeze frame data by using the intelligent tester.
    1. Connect the intelligent tester to the DLC3.
    2. Turn the engine switch on (IG) and check the freeze frame data by following the prompts the intelligent tester's display screen.
    VOLTAGE SPECIFICATION

    Item Item Description/Range (Display) Inspection Condition Reference Value
    TRQ1 Torque sensor 1 rotation angle/
    Min.: 0 deg, Max.: 360 deg    		 Steering wheel is turned Value changes from 0 to 360° every 22.5° of steering angle
    TRQ2 Torque sensor 2 rotation angle/
    Min.: 0 deg, Max.: 360 deg    		 Steering wheel is turned Value changes from 0 to 360° every 22.5° of steering angle
    SPD Vehicle speed from meter/
    Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    1. Vehicle is stopped
    2. Vehicle is driven at a constant speed
    1. 1.0 km/h (0 mph)
    2. No significant fluctuation
    ENGINE REV Engine revolution/Min.: 0 rpm, Max.: 8192 rpm Engine is running at a constant speed No significant fluctuation
    MOTOR ACTUAL Amount of current to motor/
    Min.: -128 A, Max.: 127 A    		 Power steering is in operation Value changes in proportion to steering effort
    COMMAND VALUE Demanded amount of current to motor/
    Min.: -128 A, Max.: 127 A    		 Power steering is in operation Value changes in proportion to steering effort
    STR ANGL VEL Steering angle speed/Min.: -4096 deg/sec, Max.: 4064 deg/sec Steering wheel is turned Value changes in proportion to steering speed
    THERMISTOR TEMP ECU substrate temperature/
    Min.: -50 °C, Max.: 205°C    		 Engine switch on (IG) -
    PIG SUPPLY Power source voltage to activate motor/
    Min.: 0 V, Max.: 25.5 V    		 Power steering is in operation 10 to 14 V
    IG SUPPLY ECU power source voltage/
    Min.: 0 V, Max.: 25.5 V    		 Engine switch on (IG) 10 to 14 V
    TRQ1 ZERO VAL Zero point value of torque sensor 1/
    Min.: 0 deg, Max.: 360 deg    		 Steering wheel is not turned (without load) Values differ depending on vehicle
    TRQ2 ZERO VAL Zero point value of torque sensor 2/
    Min.: 0 deg, Max.: 360 deg    		 Steering wheel is not turned (without load) Values differ depending on vehicle
    STEERING TORQUE Steering torque/Min.: -7.0 N*m, Max.: 7.0 N*m Steering wheel is turned Value changes in proportion to steering effort
    MOTOR ROTATE Motor rotation angle/Min.: 0 deg, Max.: 360 deg Steering wheel is turned Value changes from 0 to 360° every 22.5° of steering angle
    COMMAND VALUE 2 Demanded amount of current to motor 2/Min.: -128 A, Max.: 127 A - -
    PIG2 VOLTAGE Motor drive voltage after pressurization Power steering is in operation 27 to 34 V
    MOTOR VOLTAGE Motor power source voltage/Min.: 0 V, Max.: 64 V Power steering is in operation 27 to 34 V
    MTR TERMINAL (U) Motor terminal voltage (U phase)/
    Min.: 0 V, Max.: 64 V    		 Power steering is in operation 27 to 34 V
    MTR TERMINAL (V) Motor terminal voltage (V phase)/
    Min.: 0 V, Max.: 64 V    		 Power steering is in operation 27 to 34 V
    MTR TERMINAL (W) Motor terminal voltage (W phase)/
    Min.: 0 V, Max.: 64 V    		 Power steering is in operation 27 to 34 V
    STR SENS SIG Steering angle sensor signal status/
    OK or NG    		 - -
    MTR OVERHEAT Continuous overheat prevention control record/
    REC or UNREC    		 - -
    MTR LOW POWER PIG power source voltage drop record/
    REC or UNREC    		 - -
    ENG REV INTER Record of engine revolution signal interruption/REC or UNREC - -
    STR ANGL INTER Record of steering angle sensor signal interruption/REC or UNREC - -
    SPD SIG INVALID Record of vehicle speed signal invalid/
    REC or UNREC    		 - -
    CONTROL MODE Codes indicating DTC detection timing during ECU control are displayed in hexadecimal - -
    IG ON/OFF TIME Number of times IG switch is turned on after DTC detection/
    Min.: 0 time, Max.: 255 times    		 - -
    # CODES Number of detected DTCs when freeze frame data is stored/
    Min.: 0, Max.: 255    		 - -
    ASSIST MAP Selected assist map/01 to 09, 11 or 12 - -
    ECU I.D ECU identification information/01 to 09, 11 or 12 - -
    TEST MODE STAT Selected mode/
    NORMAL or TEST    		 - -
scientia non olet · About LEMON Manuals