ABSORBER CONTROL ACTUATOR (for Front Side): Installation

INSTALL ABSORBER CONTROL ACTUATOR
1. Install the absorber control actuator to the actuator support bracket.
2. Turn the actuator clockwise 40° until a click is felt.
  NOTE: Do not turn the actuator more than 40°.
  
  Fig 1: Turning Actuator Clockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHOCK ABSORBER CAP UPPER
1. Connect the connector.
2. Install the front shock absorber cap upper with the 3 nuts.
  
  Fig 2: Locating Front Shock Absorber Cap Upper And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 20 N*m (202 kgf*cm, 15 ft.*lbf)
INSTALL ENGINE ROOM SIDE COVER LH (See INSPECTION PROCEDURE )
INSTALL ENGINE ROOM SIDE COVER RH (See INSPECTION PROCEDURE )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSPECTION PROCEDURE )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.