Cruise Control Main Switch: Installation

INSTALL CRUISE CONTROL MAIN SWITCH
1. Install the switch with the 2 screws.
  
  Fig 1: Locating Screws And Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 1.7 to 3.0 N*m (17 to 31 kgf*cm, 15 to 27 in.*lbf)
2. Connect the connector.
INSTALL STEERING WHEEL ASSEMBLY
For 3GR-FSE (see INSTALLATION )

For 3UZ-FE (see INSTALLATION )
INSTALL STEERING WHEEL PAD (See INSTALLATION )
INSTALL STEERING WHEEL NO. 3 COVER LOWER
INSTALL STEERING WHEEL NO. 2 COVER LOWER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Perform initialization (see INITIALIZATION ).
CHECK SRS WARNING LIGHT
Check the SRS warning light (see DIAGNOSIS SYSTEM ).