LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GS 430 >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Park Assist/Monitoring >> Ultrasonic Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ultrasonic Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  3. REMOVE ENGINE UNDER COVER (See  REMOVAL  ) 
  4. REMOVE FRONT FENDER LINER LH (See  REMOVAL  ) 
  5. REMOVE FRONT FENDER LINER RH (See  REMOVAL  ) 
  6. REMOVE FRONT BUMPER COVER (See  REMOVAL  ) 
  7. REMOVE NO. 3 ULTRASONIC SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the sensor from the sensor retainer as shown in the illustration.
      Fig 1: Removing Sensor From Sensor Retainer
      G05300003Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the sensor retainer as shown in the illustration.
      Fig 2: Removing Sensor Retainer
      G05300004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE REAR NO. 1 BUMPER PLATE (See  REMOVAL  ) 
  9. REMOVE REAR BUMPER COVER (See  REMOVAL  ) 
  10. REMOVE NO. 2 ULTRASONIC SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the sensor retainer.
    3. Remove the sensor from the rear bumper.
    Fig 3: Removing No. 2 Ultrasonic Sensor
    G05300005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE NO. 1 ULTRASONIC SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the sensor retainer.
    3. Remove the sensor from the rear bumper.
    Fig 4: Removing No. 1 Ultrasonic Sensor
    G05300006Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals