LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (4GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
      Fig 1: Identifying Crankshaft Position Sensor Connector And Crankshaft Position Sensor Bolt
      G04973878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) (See  INSTALLATION  ) 
  3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 4WD) (See  INSTALLATION  ) 
  4. INSTALL DISCHARGE HOSE SUB-ASSEMBLY (See  INSTALLATION  ) 
  5. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE (See  INSTALLATION  ) 
  6. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) (See  INSTALLATION  ) 
  7. INSTALL OIL FILTER BRACKET (for 4WD) (See  REASSEMBLY  ) 
  8. INSTALL V-RIBBED BELT (See  INSTALLATION  ) 
  9. INSTALL ENGINE UNDER COVER REAR LH (for 2WD) (See  INSTALLATION  ) 
  10. INSTALL REAR ENGINE UNDER COVER LH 
  11. INSTALL NO. 1 INLET AIR CLEANER (See  INSTALLATION  ) 
  12. INSTALL V-BANK COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  13. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  14. INSTALL ENGINE ROOM SIDE COVER RH (See  INSTALLATION  ) 
  15. CHARGE REFRIGERANT (See  REPLACEMENT  ) 
  16. WARM UP ENGINE (See  REPLACEMENT  ) 
  17. CHECK FOR LEAKAGE OF REFRIGERANT (See  REPLACEMENT  ) 
scientia non olet · About LEMON Manuals