4WD Control Ecu: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL 4WD CONTROL ECU
1. Connect the connector and clamp to the 4WD control ECU.
  
  Fig 1: Identifying 4WD Control ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 4WD control ECU with the bolt and nut.
  Torque:
  
  Bolt 14 N*m (137 kgf*cm, 10 ft.*lbf)
  
  Nut 6.0 N*m (61 kgf*cm, 54 in.*lbf)
  
  Fig 2: Identifying 4WD Control ECU With Bolt And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the junction connector with the 2 clips.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL RH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER RH (See INSTALLATION )

Fig 3: Identifying Junction Connector With Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR SCUFF PLATE RH (w/o Illumination)
HINT:

Use the same procedures for the RH side and the LH side (See INSTALLATION ).
INSTALL FRONT DOOR SCUFF PLATE RH (w/ Illumination)
HINT:

Use the same procedures for the RH side and the LH side (See INSTALLATION ).