Data List / Active Test

HINT:

Using the intelligent tester's DATA LIST allows switch, sensor, actuator, and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
4. Read the DATA LIST according to the display on the tester.

   BODY (Main Body ECU) 

   BODY (MAIN BODY ECU)
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   D DOR CTY SW	Driver side door courtesy light switch signal/ON or OFF	ON: Driver side door is CLOSED OFF: Driver side door is OPEN	-
   P DOR CTY SW	Passenger side door courtesy light switch signal/ON or OFF	ON: Passenger side door is CLOSED OFF: Passenger side door is OPEN	-
   Rr. DOR CTY SW	Rear door courtesy light switch signal/ON or OFF	ON: Rear door is CLOSED OFF: Rear door is OPEN	-
   P LOCK POS SW	Front passenger side door lock position switch signal/ON or OFF	ON: Front passenger side door is unlocked ON: Front passenger side door is locked	-
   Rr LOCK POS SW	Rear door lock position switch signal/ON or OFF	ON: Rear door is unlocked OFF: Rear door is locked	-
   D/L SW-LOCK	Door control switch lock signal/ON or OFF	ON: Door control switch is pushed to lock position OFF: Door control switch is not pushed to lock position	-
   D/L SW-UNLOCK	Door control switch unlock signal/ON or OFF	ON: Door control switch Is pushed to unlock position OFF: Door control switch Is not pushed to unlock position	-

   MASTER SW (Multiplex Network Master Switch Assembly) 

   MASTER SW (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   DOOR LOCK SW	Driver side door control switch lock signal/ON or OFF	ON: Door control switch is pushed to lock position OFF: Door control switch Is not pushed to lock position	-
   DOOR UNLOCK SW	Driver side door control switch unlock signal/ON or OFF	ON: Door control switch is pushed to unlock position OFF: Door control switch is not pushed to unlock position	-
   LOCK POS SW	Driver side door unlock detection switch signal/ON or OFF	ON: Driver side door is unlocked OFF: Driver side door Is locked	-
   DOOR KEY LOCK	Driver door lock/unlock switch lock signal (key-linked lock switch) /ON or OFF	ON: Driver side door key cylinder is turned to lock position OFF: Driver side door key cylinder is turned to unlock position	-
   DOOR KEY UNLOCK	Driver door lock/unlock switch unlock signal (key-linked unlock switch) /ON or OFF	ON: Driver side door key cylinder Is turned to unlock position OFF: Driver side door key cylinder is turned to lock position	-

HINT:

Performing the intelligent tester's ACTIVE TEST allows relays, VSVs, actuators, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time.

The DATA LIST can be displayed during the ACTIVE TEST.

1. Connect the intelligent tester to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II/ACTIVE TEST.
4. Perform the ACTIVE TEST according to the display on the tester.

   BODY (Main Body ECU) 

   BODY (MAIN BODY ECU) CHART
   
   

   Item	Test Details	Diagnostic Note
   DOOR LOCK	Operate door lock motor LOCK/UNLOCK	-