ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: Special Repair Requirement
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- SAVING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to "CONFIGURATION (BCM): DESCRIPTION ".
NOTE: If "READ CONFIGURATION" cannot be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.GO TO 2
- REPLACE BCM
Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
GO TO 3
- WRITING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to "CONFIGURATION (BCM): SPECIAL REPAIR REQUIREMENT ".
GO TO 4
- INITIALIZE BCM (NATS)
Perform BCM initialization (NATS). Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
Inspection End.