Data Monitor
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
DATA MONITOR REFERENCE CHART
| Monitor Item | Condition |
|---|---|
| REQ SW-DR | Indicates [ON/OFF] condition of door request switch (driver side). |
| REQ SW-AS | Indicates [ON/OFF] condition of door request switch (passenger side). |
| REQ SW-BD/TR | Indicates [ON/OFF] condition of trunk opener request switch. |
| PUSH SW | Indicates [ON/OFF] condition of push button ignition switch. |
| IGN RLY2-F/B | Indicates [ON/OFF] condition of ignition relay 2. |
| ACC RLY1-F/B | Indicates [ON/OFF] condition of accessory relay. |
| CLUTCH SW |
NOTE:
This item is displayed, but cannot be monitored.
|
| BRAKE SW 1 | Indicates [ON/OFF] condition of brake switch. |
| DETE/CANCL SW | Indicates [ON/OFF] condition of P position. |
| SFT PN/N SW | Indicates [ON/OFF] condition of P or N position. |
| S/L -LOCK | Indicates [ON/OFF] condition of steering lock (LOCK). |
| S/L -UNLOCK | Indicates [ON/OFF] condition of steering lock (UNLOCK). |
| S/L RELAY-F/B | Indicates [ON/OFF] condition of ignition switch. |
| UNLK SEN-DR | Indicates [ON/OFF] condition of driver door UNLOCK status. |
| PUSH SW -IPDM | Indicates [ON/OFF] condition of push button ignition switch from IPDM E/R via CAN. |
| IGN RLY1-F/B | Indicates [ON/OFF] condition of ignition relay 1 from IPDM E/R via CAN. |
| DETE SW -IPDM | Indicates [ON/OFF] condition of P position from TCM via CAN. |
| SFT PN -IPDM | Indicates [ON/OFF] condition of P or N position from TCM via CAN. |
| SFT P -MET | Indicates [ON/OFF] condition of P position from TCM via CAN. |
| SFT N -MET | Indicates [ON/OFF] condition of N position from IPDM E/R via CAN. |
| ENGINE STATE | Indicates [STOP/START/CRANK/RUN] condition of engine states from ECM via CAN. |
| S/L LOCK-IPDM | Indicates [ON/OFF] condition of steering lock (LOCK) request from IPDM E/R via CAN. |
| S/L UNLOCK-IPDM | Indicates [ON/OFF] condition of steering lock (UNLOCK) request from IPDM E/R via CAN. |
| S/L RELAY-REQ | Indicates [ON/OFF] condition of steering lock relay from IPDM E/R via CAN. |
| VEH SPEED 1 | Display the vehicle speed signal received from combination meter by numerical value [Km/h]. |
| VEH SPEED 2 | Display the vehicle speed signal received from ABS or VDC or CVT by numerical value [Km/h]. |
| DOOR STAT-DR | Indicates [LOCK/READY/UNLK] condition of driver side door status. |
| DOOR STAT-AS | Indicates [LOCK/READY/UNLK] condition of passenger side door status. |
| ID OK FLAG | Indicates [SET/RESET] condition of key ID. |
| PRMT ENG STRT | Indicates [SET/RESET] condition of engine start possibility. |
| PRMT RKE STRT |
NOTE:
This item is displayed, but cannot be monitored.
|
| KEY SW -SLOT | Indicates [ON/OFF] condition of key slot. |
| RKE OPE COUN1 | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. |
| RKE OPE COUN2 |
NOTE:
This item is displayed, but cannot be monitored.
|
| TRNK/HAT MNTR | Indicates [ON/OFF] condition of trunk lid. |
| RKE-LOCK | Indicates [ON/OFF] condition of LOCK signal from Intelligent Key. |
| RKE-UNLOCK | Indicates [ON/OFF] condition of UNLOCK signal from Intelligent Key. |
| RKE-TR/BD | Indicates [ON/OFF] condition of TRUNK OPEN signal from Intelligent Key. |
| RKE-PANIC | Indicates [ON/OFF] condition of PANIC button of Intelligent Key. |
| RKE-P/W OPEN | Indicates [ON/OFF] condition of P/W DOWN signal from Intelligent Key. |
| RKE-MODE CHG | Indicates [ON/OFF] condition of MODE CHANGE signal from Intelligent Key. |