Removal and Installation: Notes
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before removal, disconnect the battery negative terminal.
- To disconnect the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged. To connect the brake tubes, use a flare nut torque wrench to tighten to the specified torque.
- Do not drop the ABS actuator and electric unit (control unit).
- Do not remove and install the ABS actuator and electric unit (control unit) by holding it by the harness.
- After installation, bleed the air from the brake lines. Refer to "BLEEDING BRAKE SYSTEM ".