Control When Handle Pulled When Operating Enable Conditions Not Yet Met
WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
OPERATING ENABLE CONDITIONS CHART
| Items | Operation condition | Not met case | Control |
|---|---|---|---|
| Main switch | ON | OFF | Manual mode (after finishing open/close operation if active) |
| A/T selector lever P position | P position | Other than P position | Power close operation only |
| Voltage drop | 11V or more | 11 > V > 9 | Power operation will continue but will not begin from full close position |
| 9 > V > reset voltage | Power operation will stop and warning chime will sound | ||
| Reset voltage > V | No power function available | ||
| Handle switch | Normal | Error | No operation |