Inlet Port Memory Function (FRE): Description
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- If the ignition switch is turned to the OFF position while the FRE (refresh) switch is set to ON (fresh air intake), "Perform the memory" or "Do not perform the memory" of the FRE (refresh) switch ON (fresh air intake) condition can be selected.
- If "Perform the memory" was set, the FRE (refresh) switch will be ON (fresh air intake) when turning the ignition switch to the ON position again.
- If "Do not perform the memory" was set, the air inlets will be controlled automatically when turning the ignition switch to the ON position again.
How to set
Using CONSULT-III, perform "FRE MEMORY SET" in "WORK SUPPORT" of HVAC.
WORK SUPPORT ITEMS CHART
| Work support items | Display | Setting |
|---|---|---|
| FRE MEMORY SET | WITHOUT (initial status) | Perform the memory of manual FRE |
| WITH | Do not perform the memory of manual FRE (auto control) |
NOTE:
When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10V or less, the setting of the FRE switch memory function may be cancelled.