DTC Confirmation Procedure: Notes

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

NOTE:

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
P0400 will not be displayed at "SELF-DIAG RESULTS" mode with CONSULT-III even though DTC work support test result is NG.

TESTING CONDITION:

Before performing the following procedure, confirm battery voltage is more than 10V at idle, then stop engine immediately.
For best results, perform the test at a temperature of 5°C (41°F) or higher.