Inspection Procedure

1. Disconnect the distance control ECU connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   D2-1 (+B) - Body ground	Ignition switch on	10 to 14 V

3. Measure the resistance according to the value(s) in the table below.

Standard resistance 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Identifying Terminals Of Distance Control ECU

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE