Problem Symptoms Table
HINT:
- If there is no DTC output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to relevant troubleshooting page.
- Inspect the fuse before inspecting the circuits shown in the chart below.
- Inspect each malfunctioning circuit in numerical order for the corresponding symptoms.
AXLE CONTROL SYSTEM
AXLE CONTROL SYSTEM PROBLEM SYMPTOMS CHART
| Symptom | Suspected area | See |
|---|---|---|
| "CHECK AWD SYSTEM" is displayed | 1. Check DTC again and make sure that the DTC is not output | DTC CHECK / CLEAR |
| 2. CAN communication system | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 3. Multiplex communication system | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 4. Hybrid control system | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 5. Brake control system | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 6. AWD warning circuit | AWD WARNING REMAINS ON | |
| 7. Skid control ECU | SKID CONTROL ECU | |
| 8. HV control ECU | REMOVAL |
HINT:
Use the table below to help find the cause of the problem. Check each part. If necessary, replace these parts.
AXLE SYSTEM
AXLE SYSTEM - PROBLEM SYMPTOMS CHART
| Symptom | Suspected area | See |
|---|---|---|
| Wander | 1. Wheel alignment (Front) | FRONT WHEEL ALIGNMENT |
| 2. Wheel alignment (Rear) | REAR WHEEL ALIGNMENT | |
| 3. Steering linkage | INSPECTION | |
| 4. Hub bearing (Font) | ON-VEHICLE INSPECTION | |
| 5. Hub bearing (Rear) | ON-VEHICLE INSPECTION | |
| 6. Stabilizer bar (Front) | REMOVAL | |
| 7. Stabilizer bar (Rear (2WD)) | INSPECTION | |
| 8. Stabilizer bar (Rear (4WD)) | INSPECTION | |
| Wheel shimmy | 1. Wheel balance | INSPECTION |
| 2. Shock absorber (Front) | INSPECTION | |
| 3. Shock absorber (Rear) | INSPECTION | |
| 4. Hub bearing (Front) | ON-VEHICLE INSPECTION | |
| 5. Hub bearing (Rear) | ON-VEHICLE INSPECTION |