Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BLUETOOTH SETTINGS
1. Check if the BLUETOOTH settings are correct.
  OK: BLUETOOTH settings are correct.
- NG: SET SETTINGS CORRECTLY
- OK: GO TO NEXT STEP
CHECK CELLULAR PHONE
1. Check if the cellular phone is BLUETOOTH capable.
  HINT:
  
  Some versions of BLUETOOTH capable cellular phones may not be compatible.
  
  OK: The phone is BLUETOOTH capable.
- NG: END (ONLY A BLUETOOTH CAPABLE CELLULAR PHONE CAN BE USED)
- OK: GO TO NEXT STEP
CHECK SETTINGS
1. Check if the cellular phone functions.
  HINT:
  - The cellular phone is unable to make a call under any of the following conditions.
  - The cellular phone is locked.
  - The dictionary is being transferred.
  - The line is crossed.
  - Transmission is requested.
  - The power is off.
  - The cellular phone is not connected to BLUETOOTH ("BT" is displayed while a connection is present).
    OK: No of the above conditions exist.
- NG: SET SETTING CORRECTLY
- OK: GO TO NEXT STEP
CHECK CELLULAR PHONE
1. Check if the cellular phone can make a call.
  HINT:
  
  When the battery charge is low, calls cannot be made or received.
  
  OK: The cellular phone can make a call.
- NG: REPLACE CELLULAR PHONE
- OK: GO TO NEXT STEP
CHECK RECEPTION
1. Put a cellular phone into a receiving state.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.
  OK: The cellular phone has reception.
- NG: REPLACE MULTI-DISPLAY
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE