Data List/Active Test
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON.
- Read the DATA LIST according to the display on the tester.
Body ECU
DATA LIST (BODY ECU)Item Measurement Item/Display (Range) Normal Condition Diagnostic Note D DOR CTY SW Driver's door courtesy switch signal ON: Driver's door is open
OFF: Driver's door is closed- P DOR CTY SW Passenger's door courtesy switch signal ON: Passenger's door is open
OFF: Passenger's door is closed- Rr DOR CTY SW Rear door courtesy switch signal ON: Either right or left rear door is open
OFF: Both the right and left doors are closed- DIMMER SW Dimmer switch signal ON: Dimmer switch is ON (High Beam) or High flasher switch is ON
OFF: Dimmer switch is OFF (Low Beam) or High flasher switch is OFF- HIGH FLASHER SW High flasher switch signal ON: High flasher switch is ON
OFF: High flasher switch is OFF- AUTO LIGHT SW Auto light switch signal ON: Light control switch is Auto position
OFF: Light control switch is in except Auto position- HEAD LIGHT SW Head light switch signal ON: Light control switch is in HEAD position
OFF: Light control switch is in except HEAD position- TAIL LIGHT SW Taillight switch signal/ON ON: Light control switch is in TAIL or HEAD position
OFF: Light control switch is in OFF or AUTO position- TAIL CANCEL SW Tail cancel switch ON: Tail cancel switch is ON position
OFF: Tail cancel switch is OFF position- DRL FUNCTION DRL function ON: DRL is ON position
OFF: DRL is OFF position- ILLUMINATE RATE Illumination rate information - - LIGHTING TIME Lighting time 7.5 s./ 15 s./ 30 s. - ILLUMI SYSTEM Operation of illumination system ON: Illumination is ON position
OFF: Illumination is OFF position- LIGHT CONTROL Light control condition of illumination system ON: Illumination system is ON
OFF: Illumination system is OFF- I/L ON/ACC OFF Light the I/L when ACC OFF ON: Light the I/L when ACC OFF is ON position
OFF: Light the I/L when ACC
OFF is OFF position- I/L ON/UNLOCK Interior light ON w/unlock ON: Interior light ON w/unlock is ON position
OFF: Interior light ON w/unlock is OFF position- RESPONSE TIME Response time 0.1 s./ 1.0 s. -
- PERFORM ACTIVE TEST
HINT:
Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other item values to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON.
- Perform the ACTIVE TEST according to the display on the tester.
Body ECU
ACTIVE TEST (BODY ECU)Item Test Details Diagnostic Note HAZARD Turns hazard light flasher relay ON/OFF - HEAD LIGHT Turns head light relay ON/OFF - HEAD LIGHT (HI) Turns head light relay ON/OFF - TAIL LIGHT Turns taillight relay ON/OFF - DRL RLY (Test Details)
Turns DRL relay ON/OFF
(Vehicle Condition)
Ignition switch is ON, engine is stopped and
light control switch is in OFF position.- DIMMER SIG Turns auto dimmer ON/OFF - ILLUMI OUTPUT (Test Details)
Turns interior light and key illumination ON/
OFF
(Vehicle Condition)
Interior light switch is in door position- OPN DOR WRN LGT Open door warning light ON/OFF - R ROOM LIGHT Rear room light ON/OFF - CONSOLE LIGHT Center console light ON/OFF - STEP LIGHT Side step light and outer foot light ON/OFF No k in ignition cylinder SCUFF PLATE LEG Foot light and inside door handle illumination ON/OFF -