LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Engine Control System (2GR-FE)) >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL KNOCK SENSOR 
    1. Install the 2 sensors with the 2 bolts as shown in the illustration.

      Torque: 20 N*m (205 kgf*cm, 15 ft.*lbf) 

      NOTE: Make sure that the knock sensor is in the correct position.
    2. Connect the 2 sensor connectors.
    Fig 1: Identifying Knock Sensor
    G05184286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INTAKE MANIFOLD  (see INSTALLATION )
  3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (see INSTALLATION )
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. CHECK FOR ENGINE COOLANT LEAKS  (see ON-VEHICLE INSPECTION )
  6. CHECK FOR FUEL LEAKS 
  7. CHECK FOR ENGINE OIL LEAKS  (see INSPECTION )
scientia non olet · About LEMON Manuals