Occupant Classification System: Precaution
WARNING: This page is about a different car, the 2006 Lexus RX 400h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.
INITIALIZE SYSTEM REFERENCE
| System Name | See procedure |
|---|---|
| Lighting System | INITIALIZATION |
| Sliding Roof Control System | INITIALIZATION |
| Power Window Control System | INITIALIZATION |
| Power Door Lock Control System | INITIALIZATION |
| Power Back Door Control System | INITIALIZATION |
| Back Door Closer System | INITIALIZATION |
| Electrical Back Door Outside Handle System | INITIALIZATION |
| SFI System | INITIALIZATION |
- INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT
- Perform the zero point calibration and sensitivity check if any of the following conditions occur.
- The occupant classification ECU is replaced.
- Accessories (seatback tray and seat cover, etc.) are installed.
- The front passenger seat is removed from the vehicle.
- The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.
- The vehicle is brought to the workshop for repair due to an accident or a collision.
NOTE: When an accident vehicle is brought into the workshop for repair, check the flatness of the body side that is equipped with the passenger seat. If the flatness is not within +- 3.0 mm (0.118 in.), adjust it to the specified range.
- Perform the zero point calibration and sensitivity check if any of the following conditions occur.