Data List / Active Test
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
HINT:
Using the Techstream to read the DATA LIST allows the values or states of switches, sensors, actuators and other item values to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Cruise Control / Data List.
- Read the Data List according to the display on the Techstream.
ECM - DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note CCS Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) Actual vehicle speed - CCS Mem Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 200 km/h (125 mph) Actual stored vehicle speed - Cruise Request Torque Cruise control request torque / min.: -1024 N*m, max.: 1016 N*m Actual required torque - Cruise Control Cruise control system active condition / ON or OFF ON: Cruise control activated
OFF: Cruise control inactivated- Main SW M-CPU Main SW (Main CPU) / ON or OFF ON: Main SW ON (pushed on)
OFF: Main SW OFF (pushed off)"3" CCS Ready M-CPU Cruise controle system standby condition (Main CPU) / ON or OFF ON/OFF : Change ON/OFF each time main switch is pushed in. "1" CCS Indicator M-CPU Cruise indicator signal (Main CPU) / ON or OFF ON : "CRUISE" ON
OFF : "CRUISE" OFF"2" Cancel Switch CANCEL SW signal / ON or OFF ON : CANCEL SW ON
OFF : CANCEL SW OFF- SET/COAST Switch - /SET SW signal / ON or OFF ON : - /SET SW ON
OFF : - /SET SW OFF- RES/ACC Switch + /RES SW signal / ON or OFF ON : +/RES SW ON
OFF : +/RES SW OFF- Stp Light SW M-CPU Stop light switch signal (Main CPU) / ON or OFF ON : Brake pedal depressed
OFF : Brake pedal released- Cruise Operation Status PNP SW Signal (D position) / ON or OFF ON : Shift D position
OFF : Except shift D position- # Codes
Number of DTC recorded / 0 to 255min.: 0
max.: 4- HINT:
"3 " is OK but "1" is NG → ECM failure
"1" is OK but "2" is NG → DTC output or ECM failure
"3" is OK but the cruise indicator does not come on → CRUISE main indicator, wire harness or ECM failure