LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Lighting System) >> Lighting System >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using a Techstream to read the DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the tester on.
    4. Enter the following menus: Body electrical / Main Body / Data List.
    5. According to the display on tester, read the "Data List".

    MAIN BODY (MAIN BODY ECU): 

    DATA LIST

    Item Measurement Item/Range Normal Condition
    D Door Courtesy SW D Door Courtesy SW/ON or OFF ON: Driver door open
    OFF: Driver door closed
    P Door Courtesy SW P Door Courtesy SW/ON or OFF ON: Front passenger door open
    OFF: Front passenger door closed
    RR Door Courtesy SW RR Door Courtesy SW/ON or OFF ON: Rear right side door open
    OFF: Rear right side door closed
    RL Door Courtesy SW RL Door Courtesy SW/ON or OFF ON: Rear left side door open
    OFF: Rear left side door closed
    Back Door Courtesy SW(1) Back Door Courtesy SW/ON or OFF ON: Back door open
    OFF: Back door closed
    Luggage Courtesy SW(2) Luggage Courtesy SW/ON or OFF ON: Luggage compartment door open
    OFF: Luggage compartment door closed
    (1) Hatchback
    (2) Sedan
  2. PERFORM ACTIVE TEST 

    HINT:

    Using a Techstream to perform the ACTIVE TEST allows relays, VSV, actuators and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the tester on.
    4. Enter the following menus: Body electrical / Main Body / Active Test.
    5. According to the display on tester, read the "Active Test".

    ACTIVE TEST: 

    ACTIVE TEST

    Tester Display Test Part Control Range
    Illuminated Entry System Room ligt assembly (room light assembly switch in DOOR position, all doors closed) ON / OFF
    Hazard Turn Signal Flasher Assembly ON / OFF
    Taillight Relay Taillight Relay ON / OFF
    Headlight Relay Headlight Relay ON / OFF
scientia non olet · About LEMON Manuals